This is a quick post to describe how to reclaim disk space being used by an old Windows install. Recently, I upgraded to Windows 11 from Windows 10. I noticed that I was starting to run a bit low on
NAT Overload Towards Specific Host
This is a quick post on how to perform NAT overload (PAT) towards a specific host only. I have an inside network of 10.10.1.0/24. I need a host in this network to reach the host 192.168.0.1. They don’t have direct
PMTUD in MPLS-enabled Networks
In the previous post on MSS, MSS Clamping, PMTUD, and MTU, we learned how PMTUD is performed by setting the Don’t fragment flag in the IP header which leads to the device that needs to perform fragmentation dropping the packet
MSS, MSS Clamping, PMTUD, and MTU
Maximum Segment Size (MSS) and MSS clamping are concepts that can be confusing. How do they relate to the MTU (Maximum Transmission Unit)? Before we setup a lab to demonstrate these concepts, let’s give some background. Note that this entire
Not All OSPF Inter-area Traffic Traverses Interfaces In Area 0
Everyone knows that OSPF is a link state protocol. Those that study also discover that OSPF behaves like distance vector between areas as Type-1- and Type-2 LSAs are not flooded between areas, but rather summarized in Type-3 LSAs. This means
Ethernet History Deepdive – Why Do We Have Different Frame Types?
In my previous post Encapsulation of PDUs On Trunk Ports, I showed what happens to PDUs when you change the configuration of a trunk. You may have noticed that there are typically three different types of Ethernet encapsulations that we
Why Are OSPF Type 5 LSAs Flooded?
I recently saw a great question on Reddit, on why Type-5 (AS-external) LSAs are flooded, in comparison to Type-3 (Summary) that are regenerated at the ABR. To investigate this, we’ll use the following simple topology where R2 and R3 are
Some History on VLAN 1 in Cisco Switches
Over the years, there has been a lot of discussion on if VLAN 1 in Cisco switches is special or not. Does it have any characteristics that other VLANs don’t? I covered some of this in the Is VLAN 1
Encapsulation of PDUs On Trunk Ports
When I studied for my CCIE almost 15 years ago, I recall that I was fascinated by how different PDUs such as CDP, DTP, STP would have different encapsulations on a trunk depending on the configuration of it. What happens
Adding Arista Switch to CML
I wanted to add Arista switches to CML to do some STP interopability testing. However, the process of adding them is not well described. I had to refer to some Youtube videos to understand what to do. This is what