This is some notes for the post that I did on conditional BGP advertisement.
I found an easier way of seeing the status for the advertise-map. It is
available by looking at the neighbor status, look at the following output.

Rack7R3#show bgp ipv4 uni nei 155.7.37.7 | i Condition
Condition-map NON_EXIST, Advertise-map ADVERTISE, status: Advertise

The prefix is currently being advertised. Then we bring up the interface.

Rack7R3(config)#int s1/2
Rack7R3(config-if)#no sh

Rack7R3#show bgp ipv4 uni nei 155.7.37.7 | i Condition
Condition-map NON_EXIST, Advertise-map ADVERTISE, status: Withdraw

The prefix is no longer advertised. Remember that the BGP scanner runs every
60 seconds by default so it may take some time before we see results.

Conditional BGP, showing status
Tagged on:     

Leave a Reply

Your email address will not be published. Required fields are marked *